How to make you very own Ghetto Chain Tensioner!!
parts needed:
good tape dispenser
3 large Zip Ties
20 Minutes
scissors

#1: making the chain tensioner body!
you need to cut 2 holes in the body of the tape dispenser.
1st takes off the end where the tape normally is cut.
2nd on the other side for the chain to pass through

#2 mounting the beast!
you must put it around  the chain,
most will split and can be clamped around the chain.
take 1 or 2 of the long zip ties connected together,
and wrap it through the hole of the dispenser,
and over your chain stay.
take the other long zip tie,
and wrap it around the other zip ties.
in a horizontal way.

#3 adjusting your GCT!
adjust by tightening the zip ties,
(works best with single ring in front)

#4 testing it!
test the beast!
try shifting,
it works!!!
enjoy your new ghetto chain tensioner!
(works good with single speeds)
(makes a little noise)